cb500t seat part 2 of 3

This isn’t the biggest update but it shows what I’m working towards.

I’m using the back half of a rusted out 500t tank to make my seat cowl. I wanted to slim it down so I cut out a 1 3/4″ section and welded it back together.

Mock up.

2 responses to “cb500t seat part 2 of 3”

  1. chris says:

    that’s lookin good adam.

  2. andrew says:

    def starting to come together!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Random
Blast
From Past

Published - May 10, 2010

CB360T Pod Filters

Took the rubber manifold from the stock air filters and installed the pods on that instead of directly to the carb body so they clear the battery box. Bike sounds even better now. However, there is a small flat spot in the rpm range around 3/4 throttle. Any suggestions on jetting? Plugs are nice and […]