Machining Videos | Abom79

Published - Feb 28, 2017
Category -
Comments - 1

In another life I think I could have been a machinist. I originally came across this guys youtube from a post on Practical Machinist about how to move machinery. This is some of the best instructional type videos I’ve seen and it helps that he uses a GoPro camera. I can’t wait to have a lathe again at some point and really learn how to use it.

If you like this stuff check out some of his motorcycle related machining videos:

Triumph Flywheel Lightening

Triumph Cylinder Modification

Clutch Modification

Triumph Hub truing

Steering Damper

Wheel Modification (24:30)

One response to “Machining Videos | Abom79”

  1. Ted C. says:
    03/01/2017 at 2:27 pm

    I didn’t even know you could shave metal off some internal parts to improve performance. Neat stuff.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Random
Blast
From Past

Published - Dec 15, 2013

Yamaha ct1 clutch springs – Barnett clutch

So… I’m really starting to rip into this jalopy. As I said earlier, the clutch slips like a mother fucker. It’s horrible. I really wanted to do Barnett springs and plates. I found the plates easily on eBay but I couldn’t find ct1 Barnett springs anywhere. On a whim I ordered dt175 springs since they […]

Categories