cb500t seat part 1 of 3

This is the beginning of my solo seat on my cb500t. I’m going for a super low, slim and minimal seat that fits with the curves of the tank.

Cutting out paper templates to get certain measurements.

Laid out the design on 16 gauge sheet metal.

muscled some bends.

Stance

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Random
Blast
From Past

Published - Feb 21, 2010

front end done

This weekend I finished fabricating the front end of my bike. Started by mocking up and drafting the gauge/switch bracket. Spray mounted my mechanical drawing onto an 1/8″ flat stock steel and then roughed out the shape with the hacksaw and cleaned it up with files. Installed! Left switch is for the High/Low beam and […]